If there’s another update, just run the cmdlet with the desired WakeEnabled parameter let your devices wake up via magic packet ). There are specific hardware and software requirements of the target computer for the Wake on LAN. When the remote network adapter hears a magic packet created for the unique MAC address of the device, the network adapter alerts the computer to power on. If the target device supports Wake on LAN, it should wake up from sleep or shutdown state. If ( -NOT ( ::GetCurrent()).IsInRole( "Administrator")) Īfter performing the above steps we should be able to see the results directly in the CIM class and in the device manager (devmgmt.msc). The Wake on LAN tool can send a specific frame (Magic Packet) to any MAC address of your choosing. When your computers are turned on, WakeMeOnLan allows you to scan your network, and collect the MAC addresses of all your computers, and save the computers list into a file. Set-WakeEnabled -InterfaceName Ethernet -WakeEnabled $true This utility allows you to easily turn on one or more computers remotely by sending Wake-on-LAN (WOL) packet to the remote computers. Since I have 175 devices I need to control, I've created some command lines for easier deployment. I am trying to enable wakeonLAN for the ethernet interface, but am receiving an error message as follows: sudo ethtool -s eth0 wol g Cannot set new wake-on-lan. For the matching, we have to use the -like operator, as there is an additional number suffix (normally _0) in the InstanceName field of the MSPower_DeviceWakeEnable instances. The actual Status is 'Error: No such interface supportedNo such interface supported'.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |